APN Configuration Information / List
Use the APN settings below when manually configuring a device. In most cases the correct APN is pushed automatically, but manual entry is sometimes required (especially with static IP plans or third-party devices).
APN Settings for U.S. Carriers
Verizon (Dynamic / Standard)
- Name: Verizon
- APN: vzwinternet
- Username / Password: Leave blank
- Authentication: None
Verizon 5G / Higher-Speed Plans (100 Mbps & 200 Mbps)
- Name: Verizon
- APN: v5ga01internet
- Username / Password: Leave blank
Verizon Static IP APNs
Verizon uses different static IP APNs based on the geographical region of the assigned static IP. Choose the APN that matches the region of your static IP.
| Region | APN | Typical States Covered |
|---|---|---|
| North East | ne01.vzwstatic | Pennsylvania, New Jersey, New York, Delaware, Maryland, Virginia, West Virginia, Ohio, Kentucky, Connecticut, Rhode Island, Massachusetts, Vermont, New Hampshire, Maine (Washington DC also groups here) |
| North West / Southeast | nw01.vzwstatic | Tennessee, North Carolina, South Carolina, Georgia, Mississippi, Alabama, Florida |
| South | so01.vzwstatic | Texas, Louisiana, Arkansas, Oklahoma, Missouri, Kansas, Colorado, New Mexico |
| Midwest | mw01.vzwstatic | Illinois, Indiana, Michigan, Wisconsin, Minnesota, Iowa, Nebraska, North Dakota, South Dakota |
| West | we01.vzwstatic | California, Nevada, Arizona, Utah, Oregon, Washington, Idaho, Montana, Wyoming (Alaska and Hawaii usually fall under West — confirm if needed) |
Static IP configuration tips:
- Username and Password are normally left blank.
- Authentication is typically set to None or PAP/CHAP depending on the device.
- The APN must match the region of your reserved/static IP. Using the wrong regional APN will prevent the static IP from working.
- If you are unsure which APN to use, contact support with your device identifier (ICCID or IMEI) and we can confirm the correct one.
- Many modems automatically receive the correct APN once the static IP is provisioned. Manual configuration is only needed when automatic provisioning fails.
AT&T
- Name: ATT
- APN: broadband
- Username / Password: Leave blank
T-Mobile
- Name: T-Mobile
- APN: fast.t-mobile.com
- Username / Password: Leave blank
UScellular
- Name: UScellular
- APN: uscc00000.enterprise0.usc-cdp
- Username / Password: Leave blank
APN Settings for Canada Carriers
Rogers
- Name: Rogers
- APN: broadband /nc
- Username / Password: Leave blank
Still having trouble?
If the device will not connect after entering the correct APN, please open a support ticket and include:
- Device make/model
- ICCID and/or IMEI
- Whether the line is dynamic or static IP
- Any error messages shown
We can verify the provisioning and confirm the exact APN required.
